#AnelloArea #azzionamenti_neumatici #axionamentos_neumaticos #guias_neumaticas

#EMD #AIRring #potenciometros #potenciometer #g120c 

## Project: [16 - AIR TEST](file:///C:%5CTrabajo%5CVM%5C16%20-%20AIR%20TEST)

### Data:
***
* 2.2kw
* 

### Followed normal setup:
***

![[Pasted image 20240130154750.png]]

![[Pasted image 20240130155443.png]]

![[Pasted image 20240130155608.png]]

![[Pasted image 20240130155922.png|475]]

![[Pasted image 20240130160019.png]]

Application class:
  Application class: [1] Standard Drive Control (SDC)

Setpoint specification:
  Drive without PLC connection. Setpoint specification in the drive

Defaults of the setpoints/command sources:
  Macro drive unit: [12] Standard I/O with analog setpoint

Drive setting:
  IEC/NEMA mot stds: [0] IEC-Motor (50 Hz, SI units)
  Drive unit line supply voltage: 400 V

Drive options:
  Braking resistor active: No
  Drive filter type motor side: [0] No filter

Motor:
  Motor type selection: [1] Induction motor
  Motor connection type: Star
  Motor 87 Hz operation: No
  Rated motor voltage: 400 Vrms
  Rated motor current: 4.35 Arms
  Rated motor power: 2.20 kW
  Rated motor frequency: 50.00 Hz
  Rated motor speed: 2895.0 rpm
  Motor cooling type: [0] Natural ventilation
  Motor temperature sensor type: [0] No sensor

Motor holding brake:
  Motor holding brake configuration: [0] No motor holding brake available

Important parameters:
  Current limit: 6.52 Arms
  Minimum speed: 870.000 rpm
  Maximum speed: 4340.000 rpm
  Ramp-function generator ramp-up time: 5.000 s
  Ramp-function generator ramp-down time: 5.000 s
  OFF3 ramp-down time: 3.000 s

Drive functions:
  Technological application (Standard Drive Control): [0] Constant load (linear characteristic)
  Motor data identification and rotating measurement: [2] Identifying motor data (at standstill)


![[Pasted image 20240130155129.png]]
![[Pasted image 20240130155218.png|500]]

![[foto.jpg]]

#### Potentiometer 3US12:
***

![[20240130_154221.jpg|450]]

![[Pasted image 20240130162442.png]]

![[Pasted image 20240130162456.png]]


### Parameters changes after the setup:
***

#### For automatic Restart on Siemens G120C:
****
P1210 = 6
 * p1210 = 6: An automatic restart is carried out if any fault has occurred.

p840 = 1
* Sets the signal source for the command "ON/OFF (OFF1)"

20-55


### Aggiornamento 2024:
***

![[20240628_131621.jpg]]


![[20240628_131625.jpg]]