### For conversion from SCL-500 to control Logix
***

Open the RSS project and then Save As ACD Select

![[Pasted image 20240227220304.png]]


### For the OP panel
***
1. Open FactoryTalk View Studio
	1. New Application
	2. Select resolution
	3. Import..

![[Pasted image 20240227220644.png]]



https://www.youtube.com/watch?v=CaJQ9lVweYY

* RSLogix Project Migrator




- Convert 3 Rockwell SLC 505 PLC to Contrologix.
	- Transport PLC QT1(keep existing 1734 remote I/O but convert from Device Net to ethernet communications)
	- Robot 1 PLC QR1 (keep existing 1734 remote I/O but convert from Device Net to ethernet communications)
	- Robot 2 PLC QR2 (keep existing 1734 remote I/O but convert from Device Net to ethernet communications) ( Program will be similar to Robot 1)
- Convert all Rockwell Device Net to Ethernet. Barilla will be responsible for all wiring changes. The following list is the device Net components:
	- Power Flex 70 VFD drives.
	- 1734 remote I/O
	- Robots
	- All Panel View stations are using ethernet communications and will remain the same.
- There are 4 electrical cabinets as follows:
	- QT1 – Main PLC cabinet for transport located near case packers.
	- QT2 – Remote cabinet for transport located in warehouse near robots 1 and 2.
	- QR1 – Robot 1 PLC
	- QR2—Robot 2 PLC
	- I will provide a link, so you receive a copy of the prints. 
	   - QR1 and QT1 and QT2 are combined in a single file.						
	   - QR2 is a separate file.



•	Replace old Rockwell SLC 505’s (3 total) with new Contrologix 1756-L82E or –L83E
•	Convert SLC programs (3 total) to Contrologix. Robot 1 and Robot 2 PLC programs are similar.
•	Keep existing point I/O but replace Device Net communication module with Ethernet
•	Replace all HIM with Touch Screen HIM  2711P-T10C22D9P
•	Remove any Device net communication and replace with Ethernet
•	Convert robots to Ethernet communication
•	Replace all VFD drives with AB 525 series
•	Provide Barilla with hardware parts list for conversion
•	Increase SKU memory in PLC  to minimum of 300
•	Give possible suggestion for improvements to system
•	List any possible software/firmware changes to Robots
•	Provide a quote for conversion by February 2022
•	Provide a timeline for conversion to determine downtime
•	Update prints. Barilla will provide PDF copy of existing prints.