(* @PATH := '\/Danfoss FC' *)
TYPE FC_Control_Word
	STRUCT
		B00_RefValue_LSB			: BOOL ;	(* 	Choose between the four reference values, which are pre-programmed in par.3-10 *)
		B01_RefValue_MSB			: BOOL ;
		B02_Brake					: BOOL ;	(* 	Bit 02 = 0 leads to DC braking and stop.
													Bit 02 = 1 leads to ramping. *)
		B03_Coast					: BOOL ;	(* 	Bit 03 = 0 causes the frequency converter to immediately "let go" of the motor, so that it coasts to a standstill.
									   				Bit 03 = 1 enables the frequency converter to start the motor if the other starting conditions have been fulfilled. *)
		B04_QuickStop				: BOOL ;	(* 	Bit 04 = 0 causes a stop, in which the motor speed is ramped down to stop via par. 3-81. *)
		B05_HoldOutputFrequency	: BOOL ;	(*  	Bit 05 = 0 causes the present output frequency (in Hz) to freeze. *)
		B06_RampStop				: BOOL ;	(* 	Bit 06 = 0 causes a stop, in which the motor speed is ramped down to stop via the selected ramp down parameter.
													Bit 06 = 1 permits the frequency converter to start the motor, if the other starting conditions have been fulfilled. *)
		B07_Reset					: BOOL ;	(*  	Reset of a trip is activated on the signal’s leading edge, i.e. when changing from logic "0" to logic "1". *)
		B08_Jog					: BOOL ;	(*  	Bit 08 = 1 causes the output frequency to be determined by par. 3-19. *)
		B09_RampSelection			: BOOL ;	(*  	Bit 09 = 0 means that ramp 1 is active (parameters 3-40 to 3-47).
													Bit 09 = 1 means that ramp 2 (par. 3-50 to 3-57) is active.*)
		B10_DataValid				: BOOL ;	(*  	Bit 10 = 0 causes the control word to be ignored,
													Bit 10 = 1 causes the control word to be used. *)
		B11_Relay01Active			: BOOL ;	(*  	Bit 11 = 1 Relay 01 activated, provided Control word bit 11 has been chosen in par. 5-40.*)
		B12_Relay04Active			: BOOL ;	(*  	Bit 12 = 1 Relay 04 activated, provided Control word bit 12 has been chosen in par. 5-40.*)
		B13_SetUp_LSB			: BOOL ;	(*  	Choose between the four menu set-ups, only possible when Multi-Set-ups is selected in par. 0-10.  *)
		B14_SetUp_MSB			: BOOL ;
		B15_Reverse				: BOOL ;
	END_STRUCT
END_TYPE
(* @END_DECLARATION := '0' *)